What is the Line Settings function used for in automatic production?

[c0194112]

What is the Line Settings function used for in automatic production?

[Eric.B]

Hard for me to tell in Chinese and without a full screenshot to know where you are in the game.

If it's the old production system, Bounty #17 added the ability for the player to adjust when the auto production system adds a new production line when the AI adjusts production output. https://www.ventdev.com/forums/showthread.php?tid=3799

[c0194112]

Hard for me to tell in Chinese and without a full screenshot to know where you are in the game.

If it's the old production system, Bounty #17 added the ability for the player to adjust when the auto production system adds a new production line when the AI adjusts production output. https://www.ventdev.com/forums/showthread.php?tid=3799

If it exceeds 70%, the system will automatically build a new production line?

[Eric.B]

Hard for me to tell in Chinese and without a full screenshot to know where you are in the game.

If it's the old production system, Bounty #17 added the ability for the player to adjust when the auto production system adds a new production line when the AI adjusts production output. https://www.ventdev.com/forums/showthread.php?tid=3799

If it exceeds 70%, the system will automatically build a new production line?

Yes, in the old system, if the production speed goes above 70% it will add a new production line.

[24K_xyf]

Hard for me to tell in Chinese and without a full screenshot to know where you are in the game.

If it's the old production system, Bounty #17 added the ability for the player to adjust when the auto production system adds a new production line when the AI adjusts production output. https://www.ventdev.com/forums/showthread.php?tid=3799

If it exceeds 70%, the system will automatically build a new production line?

Yes, in the old system, if the production speed goes above 70% it will add a new production line.

Wait, this could lead to misunderstanding.

The actual situation should be that the system converts unused lines into used lines, rather than turning a 20-line factory into a 21-line one.

[Eric.B]

OK, loaded it up in English.

The top row is when the Auto Production will add a production line. By default this value is 70%. (Start a new game, design a car, set auto production on, go to factory, and check Line Settings)

So, the auto production system will increase the production speed slider until it hits 70%. When it hits 70%, it will add a new production line, and set the production speed slider to the "Decrease Line Value".

The bottom row is for when the Auto Production reduces production. By default, this is 30%. So, when the Auto production system needs to decrease production, it will lower the production slider until hits 30%. When it hits 30%, it will remove a production line and then move the production speed slider up to the "Increase Line" value.

Make sense?