Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[FIXED] Vehicle Prototyping creates generic Chassis with 0mm length and width
#1
This happens in 2nd Gear, version 2.1.0.2 when designing an engine. Substituting one of your chassis works fine. If you substituted a chassis, then go back to generic, it will use the length and width of the chassis, and a weight of negative hundreds of millions of kg. Same happens when designing a gearbox.

Generic versions of engines and gearboxes seem to be generated correctly though.
Reply
#2
Nice catch. I think this will likely happen in Classic GearCity too, unless it's an issue with the ID system.
"great writers are indecent people, they live unfairly, saving the best part for paper.
good human beings save the world, so that bastards like me can keep creating art, become immortal.
if you read this after I am dead it means I made it." ― Charles Bukowski
Reply
#3
Issue is fixed. It'll be in the next update.

Thank you again.
"great writers are indecent people, they live unfairly, saving the best part for paper.
good human beings save the world, so that bastards like me can keep creating art, become immortal.
if you read this after I am dead it means I made it." ― Charles Bukowski
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)