Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
2.3.0.x - Strength/Comfort on Chassis The Same
#1
On 2.3.0.x, while designing a chassis, the strength and comfort sliders are always the same.  It appears that they always use the strength value for both.

Changing e.g. Ride Comfort of the suspension will change other values, but not comfort.

I am not sure if this is just a display problem, or if it affects buyer appeal and other calculations as well.  But after a while of thinking the design parameters had just changed, I'm now fairly confident this is a bug.
Reply


Messages In This Thread
2.3.0.x - Strength/Comfort on Chassis The Same - by JC_Denton - 03-20-2024, 12:19 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)