08-16-2025, 03:48 PM
I am a supporter of the idea of merging trims but until then, I would like to suggest that the Modify Design window remain active when modifying a vehicle.
I'll explain:
Say that I want to end production of 5 vehicles or trims. I need to then go to the R&D -> View -> Vehicle -> select vehicle -> Modify Design -> Maybe verify -> End Production. It goes then back to the previous list, where I need to again find the next vehicle, modify design and end production.
It would be much faster if at least the window remained Modify Designs.
I could then enter Modify Design -> find the vehicle -> End production -> find next vehicle -> End production ... etc.
Staying in the Modify Design window would make it a lot easier for example when there are multiple trims for a vehicle and a new generation is introduced.
Thank you!
I'll explain:
Say that I want to end production of 5 vehicles or trims. I need to then go to the R&D -> View -> Vehicle -> select vehicle -> Modify Design -> Maybe verify -> End Production. It goes then back to the previous list, where I need to again find the next vehicle, modify design and end production.
It would be much faster if at least the window remained Modify Designs.
I could then enter Modify Design -> find the vehicle -> End production -> find next vehicle -> End production ... etc.
Staying in the Modify Design window would make it a lot easier for example when there are multiple trims for a vehicle and a new generation is introduced.
Thank you!